10 / 25
2. Carry the C430BN with one hand while holding the handle with your other hand.
The transport wheels are not designed to roll over dirty surfaces, sand can cause the wheels to
block. Lift the C430BN going from one building to another.
Assembly and installation
The C430BN almost does not require the assembly, you will have to get the wire connectors
inserted in place in the battery pack box after taking the machine from the box.
Packing
The C430BN with one charger and 2 tool sets are packed in a box.
One charger and one wrench and one hexagon screw wrench are included (refer to the below
image).
Before operation (Charge the battery)
Charge the battery pack when it is correctly connected in the machine. Make sure the battery
pack is charged monthly.
Operation (Before you start)
Check the brushes and squeegee for wear and tear.
During operation, the battery indicator on the control panel shows the amount of power left. It’s
not recommended to use the battery when charged below 40%.
Fill the cleaning solution tank
1. Remove the stopper.
2. Pour in a maximum of 4L of cleaning fluid.
3. Replace the stopper and make sure it seals tight.
4. Put the C430BN in park position.
5. Put the tank on the C430BN with the valve first.
6. Press the tank downward to break the valve seal.
7. Push the tank into place until you hear a "click".
8. Clean your hands afterwards.
To Next Page
Loading...