Prolux PLCC430BN - Cleaning and Storage

15 / 25
Cleaning and storage
1. Refill solution tank with 0.5 to l liter of clean water-.
2. Use the C430BN main on/off switch and choose MODE 7 Brush + Water/Cleaning solution +
Dry vacuum by pressing all the 3 Switches.
Cleaning the tanks
1. Dispose water or cleaning solution from both tanks in an appropriate drain.
2. To clean the recovery tank thoroughly:
 Partially fill the tank with fresh water and hold it horizontally with the holes facing up.
 Tilt the tank repeatedly, thoroughly rinsing all the dirt and debris out from the tank.
3. To clean the solution tank, follow the same procedure.
TIP: Dry the tanks
Slightly open both tank caps before storage to allow the tanks to dry.
Check the brushes and squeegee
1. Check to see if both brushes are clean and intact.
 Clean the under fresh water or replace them if necessary.
 Replace brushes if the yellow wear indicator is the same height as other bristles.
2. Check to see if the squeegee is clean and intact.
 Clean it with fresh water and wipe it with a clean, damp cloth.
 Replace the squeegee blades when necessary.
Store in an upright position
1. Please ensure that the C430BN is parked in a place where nobody can bump into it.
2. Put the C430BN in the park position.
3. Store the C430BN close to a wall with the handle pointing towards the wall and the brushes
facing away from the wall.