9 / 25
C430BN, these can tangle in rotating parts, causing serious injury or death.
Mark the job site
The C430BN is designed to leave a dry floor without slippery patches, no additional drying is
required. When running the C430BN with the vacuum function OFF please mark the job site
with a wet floor marker.
Caution
Marking the job site with a wet floor marker is not required when using the vacuum function of
the C430BN. Unless this is a mandatory work safety requirement by local law. When unsure:
mark the job site to warn passersby.
Careful when parking
Do not park the C430BN on ramps or slopes. Always Park the C430BN on a level, hard surface.
Risks after operation
Remove battery pack
It is best practice to remove the battery before executing any cleaning or maintenance task, or
before Storage.
Machine orientation
Always keep the body of the C430BN in an upright (park) position when replacing brushes
or squeegee.
Transport and Storage
General
Always keep the body of the C430BN in an upright position when filling the cleaning solution
tank or inserting the batteries.
Before storage or transport, drain the machine and remove the batteries after each use.
Park position
The Park position is the upright vertical position for storage and maintenance tasks.
1. Make sure the vacuum hose is pushed back into the machine so it cannot get squeezed.
2. Crouch down and hold the handle with one hand while holding the scrub deck with your other
hand.
3. Lift the scrub deck slowly until it stands upright on the front wheels. Guide the body towards
the scrub deck until snaps into a resting position.
Transport outside
When outside:
1. Put the C430BN in park position (refer to below image).
To Next Page
Loading...