What to do if ProMinent Water Pump shows Bus status STARTUP?
If your ProMinent Water Pump displays a 'Bus status STARTUP' message, wait briefly. Alternatively, configure the pump for active bus operation. Refer to the "Set-up" chapter for guidance.
What to do if ProMinent Water Pump shows Bus status PRE-OPERATIONAL?
If your ProMinent Water Pump displays a 'Bus status PRE-OPERATIONAL' message, wait briefly or initiate the pump via the bus.
What to do if ProMinent Water Pump shows Bus status INIT?
If your ProMinent Water Pump displays a 'Bus status INIT' message, wait briefly.
General| Dosing Accuracy | ±1% |
|---|---|
| Power Supply | 100-230 V AC, 50/60 Hz |
| Protection class | IP 65 |
| Type | Diaphragm pump |
| Stroke frequency | Up to 180 strokes/min |
| Suction Lift | 2 m water column |
| Materials | PVDF, PTFE, EPDM |
| Control | Manual or external control |
To Next Page
