ProMinent delta User Manual

Control module delta
®
Supplementary operating instructions for delta
®
Solenoid metering pump
Operating instructions
P
r
o
M
i
n
e
n
t
Three sets of operating instructions are required for the safe, correct and proper operation of the metering pumps: The
product specific operating instructions, the "General operating instructions for ProMinent
®
solenoid metering pumps" and
the operating instructions "Solenoid metering pump delta
®
with controlled solenoid drive optoDrive
®
". These operating
instructions are only valid when read together.
Original operating instructions (2006/42/EC)Part no. 986236 BA DE 012 02/10 EN
Please carefully read these operating instructions before use! · Do not discard!
The operator shall be liable for any damage caused by installation or operating errors!
Technical changes reserved.

ProMinent delta Specifications

General

Stroke rate	max. 180 strokes/min
Type	Diaphragm metering pump
Materials	PVDF, PTFE, stainless steel
Protection class	IP 65
Diaphragm material	PTFE
Drive	Solenoid
Power supply	230 V, 50/60 Hz

Summary

Safety and Responsibility

General Safety Information

Specific Safety Instructions for the control module delta®

Details safety instructions specifically relevant to the control module delta®.

Correct and Proper Use

Assembly

Commissioning Sensors

Commissioning

Initial Commissioning

Selection of the Measured Variable and Measuring Range

Guides the selection of the correct sensor type and its measurement range.

Operating Schematics / Display Symbols

Setting the Limit Values

Details how to configure upper and lower limit values for control.

Setting the Set Value

Describes how to input and adjust the desired setpoint for measurement.

Measured Variables for the Control Module delta®

Calibrating the Sensor for Chlorine

Provides detailed steps for calibrating the chlorine sensor, including zero point and gradient.

Calibrating the Sensor for pH

Provides detailed steps for calibrating the pH sensor using buffer solutions.

Calibrating the Sensor for Redox

Provides detailed steps for calibrating the Redox sensor using buffer solutions.

Troubleshooting

"Fault" Status Display

Error Control Module delta®

Status Display Warning