Table of contents
1
Introduction........................................................................... 5
1.1 Explanation of the Safety Information........................... 5
1.2 Users' qualifications...................................................... 6
2 Safety and responsibility....................................................... 8
2.1 General Safety Information........................................... 8
2.2 Specific safety instructions for the control module
delta
®
............................................................................
9
2.3 Correct and proper use............................................... 10
3 Functional description......................................................... 11
3.1
Application examples for the control module delta
®
... 11
3.2 Electrical interfaces..................................................... 13
4 Assembly............................................................................ 18
4.1 Installation (hydraulic)................................................. 18
4.2 Hydraulic test run after installation.............................. 19
4.2.1 Set the flow meter switching point........................... 19
4.3 Commissioning sensors.............................................. 20
4.3.1 Run-in time.............................................................. 20
5 Commissioning................................................................... 21
5.1 Initial Commissioning.................................................. 21
5.1.1 Selecting the operating language............................ 21
5.1.2 Selection of the Measured Variable and Measuring
Range...................................................................... 21
6 Operating Schematics / Display Symbols........................... 22
6.1 Overview of device / operating elements.................... 23
6.1.1 Key functions........................................................... 24
6.2
Continuous display extended control module delta
®
.. 24
6.3
Secondary display extended control module delta
®
... 25
6.4
Activating / deactivating the control module delta
®
.... 25
6.5 Selection of the Measured Variable and Measuring
Range......................................................................... 26
6.6 Setting the limit values................................................ 27
6.7 Setting the basic load................................................. 28
6.8 Setting the set value................................................... 29
6.9 Setting the checkout time........................................... 29
6.10
Setting the control module delta
®
............................. 31
6.11
Factory settings of the control module delta
®
...........
32
6.12 Setting the "Two-pump mode".................................. 34
6.12.1 Setting the controller pulse of the second pump.... 35
7
Measured variables for the control module delta
®
............. 36
7.1 Calibrating the sensor for chlorine.............................. 37
7.1.1 Preparing the calibration of the sensor for chlorine 37
7.1.2 Calibration of Zero Point and Gradient.................... 38
7.2 Calibrating the sensor for pH...................................... 40
7.3 Calibrating the sensor for Redox................................ 41
8 Troubleshooting.................................................................. 42
8.1 "Fault" status display.................................................. 43
8.2
Error control module delta
®
........................................ 43
8.3 Status display Warning............................................... 44
Table of contents
3
To Next Page
Loading...
Need help?
General
