Step 1: Unpacking the VTrak
3
VTrak E-Class Task List
Step 1: Unpacking the VTrak (below)
Step 2: Mounting VTrak in a Rack
• E610f/s (page 7)
• E310f/s (page 9)
Step 3: Installing Disk Drives (page 12)
Step 4: Making Management and Data Connections
• Fibre Channel (page 16)
• Serial Attached SCSI (page 21)
Step 5: Setting Up Serial Cable Connections (page 27)
Step 6: Connecting the Power (page 28)
Step 7: Setting the IP Address (page 29)
Step 8: Creating Disk Arrays with WebPAM PROe (page 35)
For complete information about your VTrak E610f/s or E310f/s subsystem, see
the
VTrak E-Class Product Manual
on the CD.
Step 1: Unpacking the VTrak
The VTrak box contains the following items:
•VTrak Unit
• Quick Start Guide
• Front bezel and key
(E310f and E310s only)
• Left and right center-mount
brackets
• Left and right mounting rails
• RJ11-to-DB9 serial data cable
• Screws for disk drives
(E610f/s: 70, including 6 spares)
(E310f/s: 50, including 2 spares)
• 1.5m (4.9 ft) Power cords (2)
• CD with SNMP files,
Product
Manual
and
Quick Start Guide
Warning
The electronic components within the VTrak disk array are
sensitive to damage from Electro-Static Discharge (ESD).
Observe appropriate precautions at all times when handling the
VTrak or its subassemblies.
To Next Page
Loading...
Need help?
General
