Your bike is delivered with a basic adjustment of the suspension elements. Before the rst ride, the air pressure in the suspension elements must be adjusted to your body weight.
// ADJUSTING THE SUSPENSION ELEMENTS
1. Unscrew the valve cap of the shock / fork.
2. Screw on the shock pump and pump the shock / fork up to the required pressure.
→ Observe the instructions for operating the shock pump.
→ We recommend a SAG* of 15% - 20% on the fork and 20% - 30% on the shock.
Please pay attention to the manufacturer's instructions of the suspension elements for the air
pressure. The corresponding manuals are included.
3. Unscrew the shock pump and screw the valve cap onto the valve.
1
* The air pressure of your suspension elements is adjusted via the so-called
SAG (negative travel). The SAG is the degree by which the shock and the fork
compresses under the weight of the rider. To adjust the SAG, sit on the bike with
all your cycling equipment (helmet, backpack, shoes, etc.) and take a normal
riding position. No air can escape when unscrewing the shock pump.
A B
To Next Page
Loading...
