PROPOINT 8561110 - Page 6

8561110
34° Clipped Head Framing Nailer
AIR TOOL PRECAUTIONS
1. Extended exposure to air tool noise may cause
hearing loss. Ear protection gear can reduce or
eliminate the noise level.
V1.0
2. Inspect the tool's airline for cracks, fraying or other
faults before each use. Discontinue use if the airline
is damaged or hissing is heard from the airline or
connectors , while operating the tool. Replace the
defective component/airline.
3. Do not allow people, mobile equipment or vehicles
to pass over the unprotected airline. Position the
airline away from high traffic areas, in a reinforced
conduit or place planks on both sides of the airline
to create a protective trench.
4. Prevent damage to the airline by observing
the following:
a. Never carry the tool by the airline.
b. Keep the airline behind the tool and out of
the tool's work path.
c. Keep the airline away from heat. oil, sharp
edges or moving parts.
d. Do not wrap the airline around the tool as
sharp edges may pierce or crack the airline.
Coil
the airline when storing.
5. A damaged or disconnected airline under pressure
may whip around and inflict personal injury or
damage the work area. Secure the compressor's
airline to a fixed or permanent structure with
clamps or cable ties.
6.
Install an in-line shutoff valve or regulator to allow
immediate control over the air supply in an
emergency, even if a hose is ruptured.
6 For technical questions call 1-800-665-8685