Remarks:
1. When there is an obstacle between the unit and the transmitter, the transmitter may not operate.
2.
When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on
the remote control of the unit, the remote operation may be unstable.
1. Press the tabs on the battery door and lift it off.
2.
Install two (2) x AAA size batteries (not included) into the battery
compartment as the figure on right and the polarity markings
inside battery compartment.
3. Replace the battery door
.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
Use only the size and type of batteries specified.
Be sure to follow the correct polarity when installing the batteries as indicated next to the battery
compartment. Reversed batteries may cause damage to the device.
Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbonzinc or
old batteries with fresh ones.
If the device is not to be used for a long period of time, remove the batteries to prevent damage or
injury from possible battery leakage.
Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer's directions.
Do not dispose of batteries in fire, batteries may explode or leak.
Clean the battery contacts and also those of the device prior to battery installation.
BATTERY INSTALLATION (REMOTE CONTROL)
AAA
AAA
10
1.
2.
3.
4.
5.
6.
7.
POWER
16ft (5m)
REMOTE CONTROL WORKING RANGE
BATTERY INSTALLATIONS
To Next Page
Loading...
Need help?
General
