EasyManua.ls Logo

ProStart CT-3400 TW Installation Guide

ProStart CT-3400 TW
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Notice
The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of
the product, be that either damage to the vehicle itself or to the unit. This unit must be installed by a certified
technician using all safety devices supplied. Only registered technicians will be eligible to use the ProStart
technical support telephone service.
Please review the Installation Guide carefully before beginning any work.
Warning
This unit is designed for vehicles with an automatic transmission only. Before installing the unit, test that the
vehicle will not start if the gear select lever is in the “Drive” position. If the vehicle starts in gear, install a manual
transmission car starter instead.
DOC. 2.53 - CT-3400TW - -September 4, 2007 - - MO - Assembled in Canada
AUTOMATIC TRANSMISSION MULTI-CHANNEL
TWO-WAY LCD REMOTE STARTER SYSTEM
WITH
VIRTUAL TACH SYSTEM
(AS PRG-1000 COMPATIBLE)
CT-3400 TW
Installation Guide
A note concerning the battery inside the transmitter:
Depending on the usage of the transmitter, the battery can last anywhere between 3 to 6
months. When the battery is low, it the transmitter will emit two beeps in a repetitive
cycle. At that point you should replace your battery with a new one. That is why we
recommend that you keep a spare battery somewhere handy such as the glove
compartment.

Table of Contents

Other manuals for ProStart CT-3400 TW

Question and Answer IconNeed help?

Do you have a question about the ProStart CT-3400 TW and is the answer not in the manual?

ProStart CT-3400 TW Specifications

General IconGeneral
BrandProStart
ModelCT-3400 TW
CategoryRemote Starter
LanguageEnglish

Related product manuals