EasyManua.ls Logo

ProStart CT-3471 TW User Manual

ProStart CT-3471 TW
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Doc#: 110602 Rev: 1.3 © 2011 - CT-3471TW - -FcN- Canada
TWO-WAY 6-BUTTON LCD AUTOMATIC/MANUAL TRANSMISSION
REMOTE STARTER
CT-3471 TW
User Guide
WARNING
!
It is the responsibility of the vehicle operator to ensure their vehicle is parked
in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL position and
the parking brake is engaged in order to avoid accidents upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in “Park” in order to avoid
accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is disabled or put
into valet mode before servicing.
A note concerning the battery inside the transmitter:
Depending on your usage of the transmitter, the battery can last anywhere between 3 to 6 months. When the
battery is low, the transmitter will produce two beeps in a repetitive cycle. At that point you should replace
your battery with a new one. That is why we recommend that you keep a spare battery somewhere handy
such as the glove compartment.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
Question and Answer IconNeed help?

Do you have a question about the ProStart CT-3471 TW and is the answer not in the manual?

ProStart CT-3471 TW Specifications

General IconGeneral
BrandProStart
ModelCT-3471 TW
CategoryRemote Starter
LanguageEnglish

Summary

Introduction

What is "eSH" Technology?

Explains the proprietary eSH technology used for enhanced radio range and reliability.

Vehicle Presets

Details recommended accessory control settings for preparing the vehicle for a successful remote start.

Using the Remote Control

Provides an overview of the 6-button remote control's functions and operational basics.

Arming and Disarming the Starter Kill

Passive Mode Operation

Describes how the Starter Kill automatically arms and disarms in Passive Mode for enhanced security.

Active Mode Operation

Explains how to manually arm and disarm the Starter Kill system using the Active Mode.

Remote-Starting Your Vehicle

Setting Your Vehicle Into Ready Mode

Provides essential instructions for enabling Ready Mode, crucial for manual transmission remote starting.

Remote Starter Features

Remote Door Locks

Details how to remotely lock and unlock vehicle doors, including arming/disarming the starter kill.

Remote Trunk Release

Instructions on how to open the vehicle's trunk remotely using the transmitter button.

Idle Mode

Explains the convenience feature allowing the engine to run while the vehicle is parked.

Valet Modes

Ignition Valet Mode

Procedure to enable Valet Mode by using the vehicle's ignition key.

Remote Valet Mode

Procedure to enable Valet Mode using the remote transmitter.

Taking the System Out of Valet Mode

Exit Valet Mode via Key

Steps to disable Valet Mode by using the ignition key.

Exit Valet Mode via Transmitter

Steps to disable Valet Mode using the remote transmitter.

Multi-Level Features

Basic Features

Access Level 1 features such as Aux 2 and cold weather mode.

Multi-Car Operation

Control multiple vehicles by accessing Level 2 features with a single remote.

Customized Features

Access Level 3 features that can be personalized by the installer for specific functions.

Transmitter Function Menus

Access menus for adjusting clock, alarm settings, and other transmitter functions.

Related product manuals