ProStart CT-3471 TW - Oem-Style Alarm; Intrusion Codes Via Horn

User Guide P.15
• Press ¾ ¾ + : ................................................. LOCK
• Press
¾ ¾ + : .................................................. UNLOCK
• Press
¾ ¾ + : ................................................................... START
• Press ¾ ¾ + : .................................................... STOP
• Press ¾ ¾ + : .................................................. TRUNK
Start/Stop While in Safe Start Mode
Function
Button press
Icon
Sound
Description
Start on safe start
mode
+ x 2
+
Melody
Press
+
simultaneously twice within 3
seconds. Press for 1 sec- a
beep will be heard- then
press 1sec and a melody will
be heard again.
Stop on safe start
mode
+
None Melody
Note: Your remote control must be configured for second car operation by the installer.
OEMStyleAlarm
The OEM-style alarm (if configured by your installer) monitors the doors, hood and ignition switch
of your vehicle. It will sound the horn if a door or the hood is opened, or if the key is turned in the
ignition.
• To arm the OEM-style alarm, press the
button on the transmitter.
- The OEM-style alarm will ONLY arm if the
button on the transmitter is pressed.
- The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now
armed.
• To disarm the OEM-style alarm, press the
button on the transmitter.
- To stop the horn from sounding if the OEM-style alarm is triggered, press the
or
button, or put the system in and out of Valet Mode (page-9)
IntrusionCodesviahorn
The system monitors the following:
• Doors
• Hood
• Ignition
Note: If an intrusion has occurred the HORN will sound for a maximum of 1minute.
If an intrusion has occurred and pressed, the horn provides an intrusion code corresponding to
the type of intrusion that occurred.
Diagnostic table:
1x = power interruption 4x = Doors intrusion
3x = Hood 6x = Ignition