ProStart CT-5072 User Manual

INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 110906 Rev:1.4 © 2011 -CT-5072- -FcN- Canada
ONE-WAY AUTOMATIC/MANUAL TRANSMISSION
REMOTE STARTER WITH FULL ALARM SYSTEM
AND VIRTUAL TACH SYSTEM
(AS PRG-1000 COMPATIBLE)
CT-5072
User Guide
WARNING !
It is the responsibility of the vehicle operator to ensure that their
vehicle is parked in a safe and responsible manner.
1. a) Manual transmission
: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user’s
responsibility to ensure that the gearshift lever is in “Park” in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.

ProStart CT-5072 Specifications

General

Brand	ProStart
Model	CT-5072
Category	Remote Starter
Language	English

Summary

WARNING!

Vehicle Parking Responsibility

Ensure vehicle is parked safely and responsibly before remote starting.

Manual Transmission Safety

Ensure neutral gear and engaged parking brake for manual transmissions.

Automatic Transmission Safety

Ensure Park gear is selected for automatic transmissions.

Servicing Safety

Disable remote starter or use valet mode before vehicle servicing.

Introduction to SmartStart™

System Overview

SmartStart™ Technology

Using the Remote Control

Transmitter Button Functions

Explains LOCK, UNLOCK, TRUNK, and START/STOP button operations.

Remote-Starting Your Vehicle

Setting Ready Mode

Procedure for setting vehicle to Ready Mode for remote start.

Remote Starting and Driving Off

Remote Starting Process

How to initiate and monitor the remote start sequence.

Driving Off Procedure

Steps to take over driving after the engine has been remotely started.

Arming and Disarming the System

Passive Mode

Active Mode

Remote Starter Features

Remote Door Locks

Idle Mode

Valet Mode

Entering Valet Mode

Methods to enable Valet Mode using Key, Transmitter, or Switch.

Exiting Valet Mode

Methods to disable Valet Mode using Key, Transmitter, or Switch.

Panic Mode

Activating Panic Mode

Emergency activation of siren and parking lights.

Quick Lockout™

Quick Lockout Function

Cold Weather Mode

Entering Cold Weather Mode

Exiting Cold Weather Mode

Safe Start for Cold Weather

Intrusion Codes via LED Light

Intrusion Detection Codes

Advanced Features: Installation-Programmable Options

Ignition-Controlled Door Locks

Secure Lock Feature

Safe Start Feature

Turbo Mode

Turbocharger Idle Down

Arming Modes

Active Arming

Passive Arming (2 Stage Disarm)

Passive Arming (1 Stage Disarm)

Shock Sense and Warn-Away Sense

Shock Sensor Operation

Diagnostics: Parking Light Flash Table

Interpreting Flash Codes

PROSTART LIMITED LIFETIME WARRANTY

Remote Starter Module Warranty

Warranty coverage for the remote starter module itself.

Accessory Warranty

Warranty coverage for system accessories.

Warranty Void Conditions

Situations that will invalidate the product warranty.

Warranty Exclusions

Items and conditions not covered by the product warranty.