EasyManua.ls Logo

ProStart CT-5072 - Remote Starter Features; Remote Door Locks; Idle Mode

Default Icon
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P.6
User Guide
2. The LED on the antenna will remain OFF.
RemoteStarterFeatures
RemoteDoorLocks
If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To UNLOCK your doors and DISARM the system:
1. Press and hold the
button for approx. 1 sec.
2. The siren will chirp twice to confirm that the doors have been unlocked, the Starter Kill
feature is disarmed (if installed) and that the Alarm is disabled.
To LOCK your doors and ARM the system:
1. Press and hold the button for approx. 1 sec.
2. The siren will chirp once to confirm that the doors have been locked, the Starter Kill
feature is enabled (if installed) and that the Alarm is armed.
RemoteTrunkRelease
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the button until the remote beeps once. In addition, this will also disarm the system.
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
Activating Idle mode (Automatic transmission):
1. With the engine running, make sure to release the brake pedal and press the ,
or button on the transmitter until the parking lights come ON.
Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Idle mode.
2. Remove the ignition key from the ignition switch.
The engine will continue running.
3. Exit the vehicle. All doors, the hood and trunk should be closed
4. Press the button to lock the doors, to arm the starter kill and to arm the alarm. The
engine will continue running.
a. When re-entering the vehicle, the user must reinsert the key into the ignition and
turn it to the ON position (not Crank
) without pressing on the brake.
b. Once the key is in the ON position, press on the brake pedal to put the
transmission in gear. Pressing the brake pedal at this step will cancel the remote
starter takeover.
c. Drive off.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode (page 4); at the last step, the button is pressed instead of the
other buttons. This will lock the doors, arm the system and leave the engine running.

Other manuals for ProStart CT-5072

Related product manuals