ProStart CT-3471TW - ENTERING PROGRAMMING MODE; Entering programming mode using the Hood Pin; PROGRAMMING THE TRANSMITTER TO THE MODULE; To program a transmitter on the second vehicle for multi-car operation;

P.2 http://www.prostart.org Quick Installation Guide
Note: If upon pressing the START/STOP button the parking lights give 3 slow flashes, make sure that the
Orange handbrake wire is not connected, the hand brake is not engaged and that the yellow loop is cut and
isolated/taped.
ENTERING PROGRAMMING MODE
These are the programming buttons:
PROGRAMMING THE TRANSMITTER TO THE MODULE
1. In programming mode (page 2) - the parking lights will stay on for up to 20 seconds.
2. Before the lights go out, turn the ignition key to OFF (if not OFF already), then ON, then OFF.
3. Press and hold the button and keep it down until the parking lights flash 5 times quickly (unit will
click). The parking lights remain lit for 20 seconds.
4. The transmitter has been stored in memory. Each unit can store 4 remotes in its memory.
5. Either close the hood to end the programming procedure or select one of the sub-menus before the lights
turn OFF.
To program a transmitter on the second vehicle for multi-car operation;
press the button (instead of ) in step 3 of the transmitter association procedure.
The Hood Pin
The Programming Assistance Button
(a.k.a. the P.A.B.)
The P.A.B. is located on the side of the module. This push button mimics the hood-pin switch in order to avoid
having to get out of the vehicle for programming. The P.A.B. will work only when the hood pin is installed
and the hood is up.
Entering programming mode using the
Hood Pin
x Press and hold the hood pin down for 4 seconds.
x Release the hood pin.
The parking lights will turn ON for 1 second.
x While the parking lights are ON, press the hood pin once more and release immediately.
The parking lights will turn ON and stay ON for 20 seconds. You now have 20 sec. to select a submenu.
Note 1: To exit programming mode, close the hood.
Note 2: For vehicles that require the ignition to be turned ON to activate the brake circuit, follow these steps to
select a submenu:
After flashing the hood, turn the ignition ON and wait for the parking lights to come ON. Then, press the brake
pedal to access the sub-menus.