ProSun LUXURA X7 User Manual (English)

Questions and Answers:

T
Theresa SanfordAug 3, 2025
What to do if my ProSun Tanning Beds unit is activated but nothing happens?
- M
  Matthew WilliamsAug 3, 2025
  If your ProSun Tanning Bed is activated but nothing happens, first check if the unit is properly connected to the power source. If the timer clears after priming, restart the timer and try again. For remote timers that aren't working, ensure they are plugged in. If issues persist, contact ProSun customer service for replacement parts. Also, incorrect voltage could be the cause; get a voltage reading from a certified technician.
B
bretthuynhAug 7, 2025
Why individual lamps do not light in my ProSun LUXURA X7 Tanning Beds?
- K
  Kevin HowardAug 7, 2025
  If individual lamps in your ProSun Tanning Beds do not light, start by ensuring the lamps are properly secured in their sockets. Turn each lamp in its socket until it illuminates. If that doesn't work, the lamps or starters might be defective and need replacement. Defective ballasts could also be the issue, but these must be replaced by a certified technician. Additionally, check for loose wires, which also require a certified technician to reconnect. Finally, consider whether the lamp lifecycle has ended.
M
Michelle GouldAug 12, 2025
What to do if the facial tanner does not light on my ProSun Tanning Beds?
- Y
  Yvonne LewisAug 12, 2025
  If your ProSun Tanning Beds facial tanner does not light, first ensure that the face tanner switch is in the “On” position and power cycle the unit. If the lamp is defective, replace it. Also, avoid switching the facial tanner from “On” to “Off” and back again too quickly; wait approximately 3 minutes after switching it off before turning it back on to allow for cool down.
R
Richard MasseyAug 16, 2025
Why does my ProSun Tanning Beds unit appear to be too hot?
- J
  jodyjacksonAug 16, 2025
  If your ProSun Tanning Beds unit appears to be too hot, make sure that all fans are free from obstructions and dust. Also, verify that the room size meets the requirements specified in the manual.
D
Dakota RiveraAug 20, 2025
How to fix abnormally warm room temperature caused by ProSun LUXURA X7 Tanning Beds?
- C
  Carla DiazAug 20, 2025
  To address an abnormally warm room temperature caused by your ProSun Tanning Beds, pull the unit away from the wall, ensuring there is at least 10-12 inches of space.