ProSun Sundream 12 - User Manual

Questions and Answers

C
Charlotte WatsonAug 12, 2025
What to do if individual lamps do not light in ProSun Sundream 12 Tanning Beds?
- R
  Robert HunterAug 12, 2025
  If individual lamps in your ProSun Tanning Beds aren't lighting, it could be due to several reasons. First, ensure the lamps are properly secured in their sockets by turning each lamp in its socket until it illuminates. If that doesn't work, the lamps or starters might be defective and need replacement. It's also possible the ballasts are defective, requiring replacement by a certified technician. Loose wires could also be the cause, and these should be reconnected by a certified technician. Finally, the lamp lifecycle may have ended.
F
Frederick MitchellAug 19, 2025
What to do if ProSun Sundream 12 Tanning Beds unit is activated but nothing happens?
- D
  David MooreAug 19, 2025
  If your ProSun Tanning Beds unit activates but nothing happens, start by checking if the unit is properly connected to a power source. If the timer clears after priming, restart the timer and try again. For remote timer issues, ensure it’s plugged in; if it still doesn’t work, contact ProSun customer service for replacement parts. Also, incorrect voltage could be a factor, so get a voltage reading from a certified technician.
J
Jennifer HarperAug 27, 2025
Why ProSun Sundream 12 Tanning Beds unit appears to be too hot?
- K
  Kelly MartinAug 27, 2025
  If your ProSun Tanning Beds unit appears to be too hot, first ensure all fans are free from obstructions and dust. Also, check that the room size meets the requirements specified in the manual.
T
Terri HawkinsSep 2, 2025
What to do if acrylic is cracked in ProSun Sundream 12 Tanning Beds?
- K
  Kimberly AllisonSep 3, 2025
  If the acrylic in your ProSun Tanning Beds is cracked, it is likely due to damage from the user or during cleaning. Contact ProSun for a replacement. A non-skilled person can replace the acrylic.