Why is my Protocol Neo-Drone AP not hovering correctly?
If your Protocol Neo-Drone AP is not hovering or strafing correctly, it might be due to a couple of reasons. First, ensure that the aircraft was on level ground during synchronization. If not, re-synchronize the aircraft and controller. Second, incorrect trim settings can also cause this issue. Try resetting the trim buttons on the controller and re-trim the flight controls.
How to fix a Protocol Neo-Drone AP that does not respond?
If your Protocol Neo-Drone AP does not respond, it could be due to a couple of reasons. First, the communication between the controller and the aircraft might not have been synchronized during setup. To synchronize, turn on the aircraft, place it on the ground, and then turn on the remote. Second, the battery power might be depleted on either the aircraft, the controller, or both. Make sure to charge the aircraft and/or replace the batteries in the controller.
What to do if Protocol neo-drone AP Drones respond to control inputs intermittently?
If your Protocol Drones' response to control inputs is intermittent or erratic, the controller battery power might be nearly depleted. Try replacing the batteries in the controller.
Instructions on how to safely take off and land the drone, including emergency shut-off procedures.
Corrects unintentional veering of the drone using trim buttons for stable flight.
Procedures for resetting trim to default and using the toss-to-launch feature.
Addresses common drone issues like non-response, erratic controls, and hovering problems.
Guide on correctly replacing drone blades, noting rotation direction and markings.
Tips to avoid losing control of the drone by testing range and maintaining visual contact.
Instructions on how to unfold and set up the included training loop for practice.
To Next Page
General