Protocol NEO-DRONE WIFI User Manual

SAFETY WARNINGS
• Read and follow instructions on how to synchronize electronics before
each flight.
• To prevent damage to people or property, always avoid contact with
other objects while in flight.
• Inspect aircraft prior to each flight and do not fly if damaged.
• Never expose product or any of its electronic parts to moisture, water,
or heat sources.
• To prevent overheating, allow battery a cool-down period
before recharging.
• To prolong engine life, allow a cool-down period between flights.
• Use only the charger and/or charging cable that is supplied with
this item.
• Do not strike, cut, or pierce the internal battery or subject it to
hard impacts.
• Do not mix old and new batteries or mix different types of batteries.
• Never attempte to modify function of vehicle or controller or attempt
repairs using parts other then those supplied by Protocol. Spare parts
are available at www.ProtocolNY.com
HAVE FUN, BUT SAFETY FIRST!
THIS DEVICE USES COMPONETS THAT OPERATE AT HIGH SPEEDS.
AS WITH ANY SUCH DEVICE, USE CAUTION TO OPERATE SAFELY.
FAILURE TO FOLLOW ANY OF THESE GUIDELINES MAY RESULT IN BODILY
INJURY OR DAMAGE TO PERSONAL OR PUBLIC PROPERTY.
1

Protocol NEO-DRONE WIFI Specifications

General

Brand	Protocol
Model	NEO-DRONE WIFI
Category	Drones
Language	English

Summary

Safety & Precautions

Safety Warnings

Provides essential safety guidelines for operating the drone.

Parts

Drone Components

Identifies and describes the main parts of the drone.

Remote Control Components

Identifies and describes the parts of the remote controller.

Remote Batteries & Phone Installation

Installing Remote Batteries

Instructions for inserting batteries into the remote controller.

Installing the Phone Mount

Steps for attaching a smartphone to the drone controller.

Charging the Drone Battery

Charging Procedure

Step-by-step guide for charging the drone battery.

Charging Precautions

Important safety and operational advice during battery charging.

Start-Up Procedure

Drone Synchronization

Process for connecting the drone and remote controller.

Engine Idle Mode

How to put the drone's engines into idle mode.

Compass Mode Operation

Explains and instructs on using the drone's compass mode.

Operation: Flying the Drone

Take-Off and Landing

Instructions for taking off and landing the drone safely.

Emergency Stop Procedure

How to immediately stop the drone's motors in an emergency.

Basic Flight Controls

Guidance on basic flight maneuvers like rotation and movement.

Performance Modes

Selecting Speed Modes

How to change between different flight speed settings.

Trim Adjustment

Sideways Trim Correction

Adjusting the drone to correct unintentional sideways drift.

Forward/Backward Trim Correction

Adjusting the drone to correct unintentional forward/backward drift.

Left/Right Turn Trim Correction

Adjusting the drone to correct unintentional spinning or turning.

Troubleshooting

Low Battery & Out of Range Alarms

Understanding and responding to low battery and out of range warnings.

Re-Calibrating the Drone

Steps to re-calibrate the drone for stability issues.

Common Issues and Solutions

Addresses common problems like no response or erratic flight.

Changing Drone Blades

Instructions on how to replace damaged or worn drone blades.

Flying Outdoors

Preventing Fly-Aways

Tips and practices to avoid losing control of the drone.

Replacement Parts & Limited Warranty

Replacement Parts Availability

Information on where to purchase spare parts for the drone.

Limited Warranty Details

Information regarding the product's warranty coverage and terms.