32
RTS 40 programmable controller RTS 40 programmable controller
Remarks:
During setting, those displays can be set while they are flickering.
Example:
To enter setpoints of programmable automatic mode press
and hold button for 3 seconds. When time is flickering
you will be able to set time zones from Mon till Fri. The
beginning time for the 1st time zone we should enter 06:00
(also it is the ending time of 6th time zone). Press to
choose ON by scrolling + and –. Then press button again
and set 26°C by scrolling + and – buttons.
When the beginning time is flickering, it is able to be set via
scrolling + and – buttons. The time setting is the beginning
of current time zone, also the end time of last time zone.
Press button again and follow previous steps to set
other time zones.
After all settings are done, please press or wait for 5
seconds to confirm settings.
After 6 time zones for Mon to Fri are done, keep pressing
___again and move to Sat. After setting time zones for Sat,
press to move to Sun.
Press button to set the 2nd time zone at 08:00 (also it
is the ending time of the 1st time zone). Press to choose
ON by scrolling + and –. Then press button again and set
24°С by scrolling + and – buttons.
When ON/OFF is flickering, it is able to be set via scrolling
+ and – buttons. When status is ON, the controller will run
according under set mode. When status is OFF, the
controller will be switched o.
When the setpoint is flickering, it is able to be changed via
scrolling + and – buttons. Even choosing OFF status,
setpoint is able to be changed. This setpoint will be the
working when the controller is turned ON. However the next
time zone will run according to automatic programmable
setting.
To Next Page
Loading...
Need help?
General