Open window detection
This function only works when room sensor or both sensors is selected. The thermostat with this function will
shut off automatically for 15 min when the window opens, as it can detect that the room temp plummets..
TROUBLESHOOTING
Fault Codes
E1 = Built-in sensor short-circuit or disconnected.
E2 = Floor sensor short-circuit or disconnected.
Note: Should a sensor fault display, please contact us for assistance.
ADVANCED SETTING (Please refer to table above)
Caution: These are normally set by technicians during initial installation.
In normal timed power ‘on’ mode, press O to enter setting.
Press
△
or
▽
to select SETUP.
Press O to enter advanced setting. Each parameter can be accessed by pressing O and adjust the values as
required using the arrow keys. (The default values are recommended and changing these may adversely
affect the way the thermostat works). Press to revert to normal screen.
To Next Page
Loading...
