Version 1.0
8
Safety Bulletin
8
DO NOT
DAILY CHECKLIST
1. DO NOT Operate, install, or repair the hoist unless trained and authorized.
2. DO NOT Operate the hoist unless you have rst read the operator’s manual.
3. DO NOT Operate the hoist without appropriate PPE and without performing a
pre-shi inspection.
4. DO NOT Operate the hoist if not complying with all required OSHA regulations.
5. DO NOT Li more than the rated load.
6. DO NOT Li people or li loads over people.
7. DO NOT Wrap the hoisting rope or chain around the load.
8. DO NOT Operate with the chain/rope not properly seated in the sprockets, drum,
or sheave.
9. DO NOT Operate unless the direction of the hook travel agrees with the direction
shown on the control.
10. DO NOT Operate the hoist unless the hook travel limit devices function properly.
(Test without a load PRE-SHIFT )
11. DO NOT Operate the hoist with twisted, kinked, damaged, dirty, or unlubricated
chain or rope.
12. DO NOT Operate a damaged or malfunctioning hoist.
13. DO NOT Operate the hoist when the hook is not centered under the hoist
14. DO NOT Remove or obscure this tag or other WARNING & SAFETY LABELS.
B30.26 Rigging Hardware.
B30.27 Material Placement Systems.
B30.28 Balance Liing Units.
B30.29 Self-Erecting Tower Cranes.
B30.30 Ropes.
TAGGED HOIST: Ensure the crane or hoist is not tagged out of order.
CONTROL DEVICES: Test Run. Ensure all motions agree with control device mark-
ing.
BRAKES: Check all motions for excessive dri and abnormal stopping distances.
HOOK: Check for damage, cracks, nicks, gouges, deformations on throat opening,
wear on saddle or load-bearing point, and twist.
HOOK LATCH: Check for proper operations.
To Next Page
Loading...
