102
Figure 4-37 TCP/UDP Port Filter Configuration
2. Click Add under the TCP/UDP Port Filter Table heading.
3. In the TCP/UDP Port Filter Table
, enter the Protocol Names to filter.
4. Set the destination Port Number (a value between 1 and 65535) to filter. See the IANA Web site at
http://www.iana.org/assignments/port-numbers for a list of assigned port numbers and their descriptions.
5. Set the Port Type for the protocol: TCP, UDP, or both (TCP/UDP).
6. Set the Interface to filter:
• Ethernet
• Wireless Slot A
• Ethernet and Wireless Slot A
• Wireless Slot B
• Ethernet and Wireless Slot B
• Wireless Slot A and B
• All interfaces
7. Click OK.
To Next Page
Loading...
