6
Commands
This chapter contains information on the following Command functions:
• Introduction to File Transfer via TFTP or HTTP: Describes the available file transfer methods.
• Update AP: Download files via TFTP or HTTP to the AP.
• Retrieve File: Upload configuration files from the AP to a TFTP server.
• Reboot: Reboot the AP in the specified number of seconds.
• Reset: Reset all of the Access Point’s configuration settings to factory defaults.
• Help Link: Configure the location where the AP Help files can be found.
To perform commands using the HTTP/HTTPS interface, you must first log in to a web browser. See Logging In for
instructions.
You may also perform commands using the command line interface. See Command Line Interface (CLI) for more
information.
To perform commands via HTTP/HTTPS:
1. Click the Commands button located on the left-hand side of the screen.
Figure 6-1 Commands Main Screen
2. Click the tab that corresponds to the command you want to issue. For example, click Reboot to restart the unit.
Following a brief introduction to TFTP and HTTP file transfer, each Commands tab is described in the remainder of this
chapter.
To Next Page
Loading...
