Proxim ORiNOCO AP-4000 - Management Parameters

Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
Parameter Tables
239
Management Parameters
Secure Management Parameters
SNMP Parameters
HTTP Parameters
* The help link must be set to an HTTP address. Use the forward slash character ("/") rather than the backslash character ("\") when configuring
the Help Link location.
Name Type Value Access CLI Parameter
Secure Management Integer 1 (enable)
2 (disable)
RW securemgmtstatus
Name Type Value Access CLI Parameter
SNMP Group N/A R snmp
SNMP Management
Interface Bitmask
Interface Bitmask 0 or 2 = No interfaces
(disable)
1 or 3 = Ethernet
4 or 6 = Wireless A
8 or 10 = Wireless B
12 = Wireless A & B
13 or 15 = All interfaces
(default is 15)
RW snmpifbitmask
Read Password DisplayString User Defined
public (default)
6 - 32 characters
W snmprpasswd
Read/Write Password DisplayString User Defined
public (default)
6 - 32 characters
W snmprwpasswd
SNMPv3 Authentication
Password
DisplayString User Defined
public (default)
6 - 32 characters
W snmpv3authpasswd
SNMPv3 Privacy
Password
DisplayString User Defined
public (default)
6 - 32 characters
W snmpv3privpasswd
Name Type Value Access CLI Parameter
HTTP Group N/A R http
HTTP Management
Interface Bitmask
Interface Bitmask 0 or 2 = No interfaces
(disable)
1 or 3 = Ethernet
4 or 6 = Wireless A
8 or 10 = Wireless B
12 = Wireless A & B
13 or 15 = All interfaces
(default is 15)
RW httpifbitmask
HTTP Password DisplayString User Defined (6 - 32
characters)
W httppasswd
HTTP Port Integer User Defined
Default = 80
RW httpport
Help Link* DisplayString User Defined RW httphelplink
SSL Status Integer enable/disable RW sslstatus
SSL Certificate
Passphrase
DisplayString User Defined W sslpassphrase