166
Figure 5-13 Mesh Statistics Link Test Sub-Tab
To execute a Link Test, set the following parameters:
• Test Type: Tree Type or Neighbor Type
• Destination System Name: The destination Mesh unit.
• Test Traffic Rate: The number of frames per second to test.
• Frame Size: The size of each frame in test.
• Test Duration: The duration for the entire whole test
When a test is running, it will appear in the “Currently RUnning Mesh Link Test” section of the page. The “Time to Finish”
field updates on each page refresh.
Upon completion of a test, the test will appear under the “Mesh Link Test Results” section of the page. To view full results,
select radio button of the desired test; results will be displayed in a new window., new window will open.
NOTES:
• No more 10 tests can be running and complete simultaneously. (For instance, if there are 5 tests running and 5 tests
finished, when a sixth test begins to run, the oldest result will be deleted.)
• Any topology change will delete all Tree Type tests (running or complete).
To Next Page
Loading...
