Proxim ORiNOCO AP-4000 - Page 201

Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
CLI Command Types
201
Figure A-10 Results of “show network” and “show ip” CLI Commands
Example 6 - Show Individual and Table Parameters
1. View a single parameter.
Syntax:
[Device-Name]>show <parameter name>
Example:
[Device-Name]> show ipaddr
Displays the Access Point IP address.
Figure A-11 Result of “show ipaddr” CLI Command
2. View all parameters in a table.
Syntax:
[Device-Name]> show <table name>
Example: [Device-Name]> show mgmtipaccesstbl
The CLI displays the IP Access Table and its entries.