212
Dynamic Channel Selection (DCS)
[Device-Name]>set dcs <1 (enable)/2 (disable)>
[Device-Name]>set dcsthreshold <value 1-10>
The values for the DCS Threshold range from 1 to 10. The default value is 5.
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Shutdown/Resume Wireless Service
[Device-Name]>set wif <index> wssstatus <1 (resume)/2 (shutdown)>
Set Load Balancing Maximum Number of Clients
[Device-Name]>set wif <index> lbmaxclients <1–63>
Set the Multicast Rate (802.11a or 4.9 GHz)
[Device-Name]>set wif 3 multrate <6, 12, 24
(Mbits/sec)>
Set the Multicast Rate (802.11b/g)
[Device-Name]>set wif 4 multrate <1, 2, 5.5, 11
(Mbits/sec)>
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif <index> supermode <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif <index> turbo <enable/disable>
NOTE: Super mode must be enabled on the interface before Turbo mode can be enabled.
NOTE: Turbo mode and Mesh mode (either Mesh AP or Mesh Portal) can not be enabled on the same interface
simultaneously.
Configure Antenna Diversity
NOTE: When the AP-4900M is in 4.9 GHz Public Safety operational mode, antenna diversity is disabled by default, and
antenna 3 is configured for use.
[Device-Name]>set wif 3 atdiversity <3, 4, 5(auto)> (see below)
[Device-Name]>set wif 4 atdiversity <1, 2, 5(auto)> (see below)
[Device-Name]>reboot 0
To Next Page
Loading...
