Proxim ORiNOCO AP-4000 - Page 217

Command Line Interface (CLI) AP-4000/4000M/4900M User Guide
Configuring the AP using CLI commands
217
MAC Address Format : dashdelimited
Response Time : 3
Maximum Retransmission : 3
Authorization Lifetime : 0
Accounting Update Interval : 0
Accounting Inactivity Timer : 5
Index : 1
Primary/Backup : Backup
Profile Name : MAC Authentication
Server Status : notReady
Server Addressing Format : ipaddr
IP Address/Host Name : 0.0.0.0
Destination Port : 1812
VLAN Identifier : -1
MAC Address Format : dashdelimited
Response Time : 3
Maximum Retransmission : 3
.
.
.
Index : 4
Primary/Backup : Backup
Profile Name : Management Access
Server Status : notReady
Server Addressing Format : ipaddr
IP Address/Host Name : 0.0.0.0
Destination Port : 1812
VLAN Identifier : -1
MAC Address Format : dashdelimited
Response Time : 3
Maximum Retransmission : 3
Authorization Lifetime : 0
Accounting Update Interval : 0
Accounting Inactivity Timer : 5
Figure A-16 Result of “showradiustbl” CLI Command
Set Rogue Scan Parameters
Perform the following command to enable or disable Rogue Scan on a wireless interface and configure the scanning
parameters.
The cycletime parameter is only configured for background scanning mode.
[Device-Name]>set rscantbl <3 or 4> mode <1 for background scanning, 2 for continuous
scanning> cycletime <cycletime from 1–1440 minutes> status <enable/disable>
NOTE: Rogue Scan cannot be enabled on a wireless interface when the Wireless Service Status on that interface is
shutdown. First, resume service on the wireless interface.