ORiNOCO
®
802.11n Access Points - Software Management Guide 114
Configure the following parameters:
Click OK and Reboot the device, if you have changed the values in the Access Control Table.
6.5.1 Add an Entry to the Access Control Table
To add new entries to the Access Control Table, click Add in the Management Access Control Table screen. The
Management Access Table Add Row screen appears:
Figure 6-25 Management Access Control - Add Row
Configure the following parameters:
Click Add, to add an entry.
:
• A maximum of five system IP addresses can be added to manage the AP device.
• You can add new entries only when the Access Table status is enabled.
Parameter Description
Access Table Status Specifies the status of the Access Control on the AP device.
By default, the Management Access Control is disabled on the device. To enable it, select
Enable from the drop down menu.
IP Address Specifies the IP address of the machine that would manage the device.
Entry Status Specifies the status of the added entry.
To configure, select Enable or Disable from the drop down menu.
Parameter Description
IP Address Specifies the IP address of the system that manages the AP device. To configure, enter the IP
address in the IP Address box.
Entry Status By default, the entry status is enabled. To configure, select the status form the drop down
menu.
To Next Page
Loading...
Need help?
General
