ORiNOCO
®
802.11n Access Points - Software Management Guide 21
Before applying commit, the system displays a confirmation message, as shown in the following figure:
Figure 3-6 Commit
Click OK, if you wish to commit the changed parameters.
On successful Commit operation, the following screen appears:
Figure 3-7 Commit Status
If the configured parameters requires reboot, on committing the following screen appears.
Figure 3-8 Commit Status with Reboot Message
3.3.2 Reboot
Reboot operation is required for any change in the key parameters to take effect. For example, settings such as configuring
the Radio Mode, IP Address, and Network Mode need reboot to take effect. See Parameters requiring Reboot, for more
details. On clicking REBOOT, system displays a confirmation window as shown below.
Figure 3-9 Reboot
To Next Page
Loading...
