ORiNOCO
®
802.11n Access Points - Software Management Guide 104
6.3 Services
The Services feature allows you to configure the management interface (HTTP/HTTPS, Telnet/SSH and SNMP) and SYSLOG
host table parameters that prevent from unauthorized access to the device.
6.3.1 HTTP/HTTPS
Navigate to MANAGEMENT > Services > HTTP/HTTPS. The configuration screen appears.
Figure 6-16 HTTP/HTTPS
Configure the following parameters in the HTTP/HTTPS screen:
Click OK and then Reboot the device for the changes to take effect.
Parameter Description
Password Specifies the password that is required to log on to the web interface.
By default, the password is set to public. To configure, enter a new alphanumeric password
with a minimum of 6 and maximum of 32 characters in the Password box.
: Special characters like - = \ " ' ? / space are not allowed in the password.
HTTP Specifies the HTTP status. HTTP allows the user to access the device through a web
interface.
To configure, Select Enable or Disable from the drop down menu.
HTTP Port Specifies the number of the port on the HTTP interface. By default, it is 80. To configure,
enter a new HTTP Port.
HTTPS Specifies the HTTPS status. HTTPS allows the user to access the device through a web
interface.
To configure, select Enable or Disable from the drop down menu. The password
configuration for HTTPS is same as configured for HTTP.
To Next Page
Loading...
Need help?
General
