ORiNOCO
®
802.11n Access Points - Software Management Guide 23
4
Basic Configuration
4.1 Basic Configuration
Tabulated below are the parameters to be configured to operate the AP device at a basic level:
This chapter contains information on the following:
• Basic Configuration
• Factory Default Configuration
• Parameters requiring Reboot
Parameter Description
IP Address If you have DHCP Server on your network, then set the Address Type as Dynamic. When set
to Dynamic, the device gets its IP Address from the DHCP Server. If there is no response from
the DHCP Server, then the device will fall back to 169.254.128.132.
If you do not have the DHCP Server on your network, change the Address Type as Static. For
details on how to configure the Address Type and the IP address, refer to IP Configuration
Country Code Select a country from the drop down menu. For more details on how to configure the
Country Code, refer to Properties
Radio Mode By default, the radio mode on both Radio1 (Interface1) and Radio 2 (Interface 2) is set to
AP. For details on how to configure the radio mode, refer to Properties
Operational Mode Default Operational Mode set on both the radios, is as tabulated below:
For details on how to change the operational mode, refer to Properties
Current Bandwidth By default, the current bandwidth is set to 40 MHz. For details on how to change the current
bandwidth, refer to Properties
: All the interface (radio) 2 parameters discussed in this chapter are applicable only to a dual-radio
device.
Device Type Operational Mode
Radio 1 Radio 2
AP-800 802.11g/n Not Applicable
AP-8000 802.11a/n 802.11g/n
AP-8100 802.11a/n 802.11g/n
To Next Page
Loading...
Need help?
General
