Tsunami MP-8100 Installation and Management Guide 100
Figure 4-41 VLAN Trunk Table Add Row
2. Enter the parameters as described in the following table.
3. Click Add.
4. Click COMMIT for the changes to take effect.
NOTE: Up to 256 VLAN IDs can be configured on the Ethernet interfaces of BSU and up to16 VLAN IDs can be
configured on the Ethernet interfaces of SU.
4.7.2.3 Access Mode
Access mode is available only on the Ethernet interface of SU. This mode is used to connect VLAN aware networks with VLAN
unaware networks. In access mode, Tagged frames with specified Access Vlan ID going out of the device through the
Ethernet interface are untagged and forwarded. The untagged frames coming into the device through the Ethernet interface
are tagged with specified Access Vlan ID and Access Vlan priority and forwarded.
To configure the Access Mode in the VLAN network
1. Click ADVANCED CONFIGURATION > VLAN > Ethernet. The VLAN Ethernet Configuration screen appears.
Field Description
Trunk Id Enter the value of the trunk VLAN Id.
Entry Status Enable or disable the status of the trunk
table entry.
To Next Page
Loading...