Tsunami MP-8100 Installation and Management Guide 108
3. Enter the parameters listed in the following table.
NOTE: The Static MAC Address Filter table supports up to 200 entries.
4. Click Add to add a new entry to the Static MAC Address Filter table.
5. Click Commit so that the filter gets applied on the network.
NOTE:
• The Wired MAC address and the Wireless MAC address should be a unicast MAC address.
• MAC Address/Mask includes 12 hexadecimal digits (each hexadecimal equals to 4 bits containing 0 or 1) which are
equivalent to 48 bit identifier.
4.8.3 Advanced Filter
In Advanced Filtering, IP protocols which are frequently used or transmitted through the network are filtered.
To view the advanced filtering
1. Click ADVANCED CONFIGURATION > Filtering > Advanced Filtering. The Advanced Filtering screen is displayed
as shown below.
Parameter Description
Wired MAC Address Specifies the MAC address of the device on the wired network
that is restricted from communicating with a device in the
wireless network.
Wired MAC Mask Specifies the range of MAC address to which this filter is to be
applied.
Wireless MAC address Specifies the MAC address of the device on the wireless
network that is restricted from communicating with a device in
the wired network.
Wireless MAC Mask Specifies the range of MAC address to which this filter is to be
applied.
Comment Specifies the comment associated with Static MAC Filter table
entry.
Status Specifies the status of the newly created filter.
To Next Page
Loading...