Tsunami MP-8100 Installation and Management Guide 109
Figure 4-48 Advanced Filtering
2. The following table describes the parameters present in the Advanced Filtering table.
NOTE:
• The Advanced Filtering table contains maximum 5 entries.
• New entries cannot be added and existing entries cannot be deleted from the Advanced Filtering table.
4.8.3.1 Editing Table Entries
1. Click Edit to modify the existing table details. The Advanced Filtering - Edit Entries page appears.
Parameter Description
Name This parameter specifies the protocol name. The following
filters are supported in Advanced Filtering:
• Deny IPX RIP
• Deny IPX SAP
• Deny IPX LSP
• Deny IP Broadcasts
• Deny IP Multicasts
Direction This parameter specifies the direction of an individual entry in
the Advanced Filter table. The direction can be Ethernet to
Wireless, Wireless to Ethernet, or both.
Entry Status This parameter specifies the status of the individual entry.
To Next Page
Loading...