Tsunami MP-8100 Installation and Management Guide 113
Example of Intra-Cell Blocking Groups
Assume that four Intra-Cell Blocking Groups have been configured on one BSU. SUs 1 through 9 are registered to the BSU.
In this example, SU 1 belongs to two groups, Group 1 and Group 3. Therefore, packets from SU 1 destined to SU 4, SU 5, SU
6, and SU 3 are not blocked. However, SU 9 belongs to group 4 only and packets from SU 9 are blocked unless sent to SU 8
or SU 2.
For configuring Intra-Cell Blocking, refer the path Configuration>Filtering>Intra Cell Blocking.
Status: To configure the Intra Cell Blocking filter, select Enable for the Intra Cell Blocking Status. This is the primary flag to
enable the complete Intra Cell Blocking Filter mechanism.
Figure 4-52 Intra Cell Blocking
For configuring Security Gateway between the links,
Status: This parameter is used to configure Security Gateway status.
Mac Address: This parameter specifies the unicast MAC address of the security gateway, to which frames will be transmitted
by the device.
Perform Commit operation to affect the changes in the device.
Group1 Group2 Group3 Group4
SU1 SU2 SU6 SU8
SU4 SU3 SU1 SU9
SU5 SU8 SU3 SU2
To Next Page
Loading...