Tsunami MP-8100 Installation and Management Guide 116
The page navigates to the WORP Intra Cell blocking MAC Table. If there are any entries existing, you can apply the existing
intra cell blocking technique by enabling them.
Figure 4-54: WORP Intra Cell Blocking MAC Table
NOTE: If the Entry Status of MAC address is disabled, then SU is not allowed to be the member of any table.
Adding table entries:
Figure 4-55: WORP Intra Cell Blocking MAC Table Add Row
MAC Address: This parameter represents the SUs wireless MAC address.
Group ID’s 1 to 16: Refers to the groups belonging to a network. This parameter is used to block or unblock the status of the
groups. For example, If Group ID 1 is enabled, the SUs in group one are allowed to communicate but any communication
from others SUs is blocked.
To Next Page
Loading...
