Tsunami MP-8100 Installation and Management Guide 119
To configure the DHCP server and DHCP Interface table
1. Click ADVANCED Configuration > DHCP > DHCP Server > Interfaces. The DHCP screen appears as shown below.
Figure 4-57 DHCP
2. Enter the appropriate parameters in the DHCP Interface Table. See the following table that lists the parameters and
their descriptions.
NOTE: To enable the DHCP Server Interface, the DHCP server pool table should have at least one range configured for
that interface.
Parameter Description
Interface Type Specifies the interface for which the DHCP Server functionality
shall be configured.
Net Mask Specifies the subnet mask to be sent to the client along with the
assigned IP address. The netmask configured here should be
greater than or equal to the netmask configured on the
interface.
Default Gateway Specifies the default gateway to be sent to the client along with
assigned IP Address. Default Gateway is a node that serves as an
accessing point to another network.
Primary DNS Specifies the primary DNS (Domain Name Server) IP address to be
sent to the client.
Secondary DNS Specifies the secondary DNS IP address to be sent to the client.
Default Lease Time DHCP Server uses this option to specify the lease time it is willing
to offer to the client over that interface.
To Next Page
Loading...