Tsunami MP-8100 Installation and Management Guide 120
3. To enable DHCP Server, select Enable for DHCP Server Status. Before enabling, in interface table there should be at
least one interface enabled on which the DHCP Server has to run and the DHCP server pool table should have at least
one entry configured for that interface.
4. In the Max Lease Time field, enter the maximum lease time.
5. Click OK.
6. To apply the configured properties of the device, click COMMIT.
NOTE: For DHCP Server to be enabled on an interface, at least one address pool must be configured for that interface.
4.9.1.1 DHCP Pool
To configure DHCP Pool
1. Click ADVANCED CONFIGURATION > DHCP > DHCP Server > Pool. The DHCP Pool screen appears as shown
below.
Figure 4-58 DHCP Pool
Comment Specifies a note for the device administrator.
Entry Status Used to enable or disable the DHCP server functionality over the
interface.
Parameter Description
DHCP Status This parameter is used to enable DHCP Server or
disable the DHCP functionality on the device.
Max Lease Time Specifies the maximum lease time for which the
DHCP client can have the IP address provided by
the Server. The value ranges from 3600-86400
seconds.
Parameter Description
Interface Specifies the interface to which the pool belongs.
Start IP Address/End IP Address Specifies the start and end IP Address of the pool.
Parameter Description
To Next Page
Loading...