Tsunami MP-8100 Installation and Management Guide 121
NOTE: Up to 5 entries per interface can be added in the IP Pool Table. A pool entry can deleted but cannot be edited.
4.9.1.2 Adding a New Pool Entry
To add a new Pool entry to the DHCP server
1. Click Add in the DHCP Pool screen. The DHCP Pool Table Add Row screen is displayed as shown below.
Figure 4-59 DHCP Pool Table Add Row
2. After entering the details, click Add. The entry will be updated in the DHCP pool table.
3. To apply the changes, click COMMIT.
4.9.2 DHCP Relay (Routing Mode only)
The DHCP relay agent forwards DHCP requests to the given DHCP server. There must be at least one entry in the
corresponding Server IP Address table to enable the DHCP Relay Agent. A maximum of 5 servers can be configured. To enable
the DHCP Relay functionality, set the DHCP Mode to DHCP Relay.
NOTE: DHCP Relay Agent parameters are configurable only in Routing mode. It cannot be enabled when NAT or DHCP
Server are enabled.
To view entries in DHCP Relay Server
• Click ADVANCED CONFIGURATION > DHCP > DHCP Relay > Relay Server.
Delete Allows the user to delete the added pool entry.
Parameter Description
To Next Page
Loading...