Proxim Tsunami MP-8100 Series - Page 122

Advanced Configuration
Tsunami MP-8100 Installation and Management Guide 122
Figure 4-60 DHCP Relay
To add Relay Server Table entry
1. Click ADVANCED CONFIGURATION > DHCP > DHCP Relay > Relay Server.
2. Click Add in the DHCP Relay Server screen. The DHCP Relay Server Add Row screen is displayed as shown below.
Figure 4-61 DHCP Relay Server Add Row
3. Enter the Server IP Address and then click Add.
4. To enable DHCP Relay, click Enable for DHCP Relay Status. Before enabling, there must be at least one IP address
configured in the DHCP Relay Server Table.
5. Click OK. To apply the changes, click COMMIT.
NOTE: To enable the DHCP Relay, the NAT functionality must be disabled.