Tsunami MP-8100 Installation and Management Guide 137
The parameters for HTTP/HTTPS are described in the following table.
5.3.2 Telnet/SSH
Figure 5-11 Telnet/SSH
The parameters for Telnet/SSH are described in the following table.
Parameter Description
Password Set a new password for the interface or interfaces (Ethernet/
Wireless) to manage the device through the Web interface. Enter
a password between 6 and 32 characters in the Password field.
The default password is “public”.
HTTP Select Enable to allow HTTP access to the device from any host.
You can also select Disable to prevent access to the device from
Web interface. Similar settings are applicable for Hypertext
Transfer Protocol over Secure Socket Layer or HTTPS.
HTTP Port Specifies the port number for HTTP interface. By default, the port
number is 80.
HTTPS Similar settings as mentioned for HTTP. The password
configuration for HTTPS is same as configured for HTTP.
Telnet/SSH Parameter settings
To Next Page
Loading...