Tsunami MP-8100 Installation and Management Guide 138
Password Set a new password for the interface or interfaces to manage the device
through the CLI. The same password is used for serial CLI also.
Tel ne t Select Enable to allow the Telnet access to the device from any host. You
can also select Disable to prevent a user from accessing the device from
the CLI. Similar settings are applicable for Secure Shell or SSH.
Tel ne t P or t Specifies the port number for Telnet interface. By default, the port
number is 23.
Telnet Sessions Specifies the number of Telnet sessions which controls the number of
active Telnet connections. By default, the number of telnet sessions
allowed is 1.
SSH Select Enable to enable SSH access to the device from any host or select
Disable to prevent a user from accessing the device.
SSH Port Enter the port number for Secure Shell port for CLI interface. By default,
the port number is 22.
SSH Sessions Enter the number of SSH sessions. By default, it is 2 sessions.
NOTE: Total number of CLI sessions allowed is 3, so the sum of
Telnet and SSH sessions cannot be more than 3. For example, if
you configure the number of Telnet sessions as 2, then the
number of SSH sessions can only be a value from 0 to 1.
To Next Page
Loading...