Tsunami MP-8100 Installation and Management Guide 140
5.3.3.1 SNMPv3 Configuration
On selecting SNMP V3, the following parameters need to be configured:
Version This parameter configures the SNMP version. The available
versions are v1-v2 and v3. By default, the SNMP starts in version
v2c.
On selecting SNMP v1-v2c, the following parameters need to be
configured. Please refer to the Tsunami MP-8100 Reference
Manual for SNMPv1-v2c Configuration.
Read Password This parameter represents the read only community name used in
SNMP Protocol. It is sent along with each SNMP GET / WALK /
GETNEXT / GETBULK request to allow or deny access to the
device. This password should be same as read password set at
the NMS or MIB browser. The default password is “public” and
range of this parameter must be between 6-32 characters.
Read/Write Password This parameter represents the read-write community name used
in SNMP Protocol. It is sent along with each SNMP GET / WALK /
GETNEXT / SET request to allow or deny access to the device. This
password should be same as read-write password set at the NMS
or MIB browser. The default password is “public” and range of
this parameter must be between 6-32 characters.
SNMP V3 Parameter settings
Security level The supported security levels for MP-8100 is AuthNoPriv and AuthPriv. Select
AuthNoPriv for Extensible Authentication or AuthPriv for both Authentication
and Privacy (Encryption).
Priv Protocol This field configures the type of privacy (or encryption) protocol. This parameter is
available only when the security level is AuthPriv. Select the encryption standard
either AES-128 (Advanced Encryption Standard) or DES (Data Encryption
Standard) from the list. The default Priv Protocol is AES-128.
Priv Password This field configures the pass key for Privacy protocol selected. This parameter is
available only when the security level is AuthPriv. The default password is
public123 and range of this field must be between 8-32 characters.
Auth Protocol This field configures the type of Authentication protocol. Select the encryption
standard either SHA (Secure Hash Algorithm) or MD5 (Message-Digest algorithm)
from the list. The default Auth Protocol is DES.
To Next Page
Loading...