Tsunami MP-8100 Installation and Management Guide 141
5.3.3.2 SNMP Trap Host Table
This table contains the list of IP addresses where the SNMP traps will be delivered. It supports maximum 5 rows.
Adding Entries to the Trap Host Table
To add entries to the Trap Host Table
1. Click Add to add Table Entries to the Trap Host Table.
Figure 5-13 SNMP Host Table Add Row
2. Enter the IP Address, Password, and Comment.
3. Select the entry status as Enable or Disable and click Add.
All traps will be delivered to the host port number 162. The community string/ password field is not valid if the device is
configured in SNMPv3 mode.
NOTE: Changes to SNMP parameters require a Reboot to take effect.
5.3.4 System Log Host Table
System log messages are generated by the system by sending requests at various instances to the system log server. The
priority with which the messages are to be logged from the configured instance can be reconfigured by selecting a desired
priority from the Log Priority drop-down menu. These system log details are lost on system reboot. System message logging
can be disabled if needed.
Auth Password This configures the pass key for Privacy protocol selected. The default password is
public123 and range of this field must be between 8-32 characters.
The default user in SNMPv3 is “admin” has all read-write privileges and only one
user is supported.
If SNMPv3 is enabled, the v3 stats can be seen in the MONITOR > SNMPv3 stats
page.
The option “None” in Security Level, Auth Protocol and Priv Protocol is present to
support the parameters in lower versions and is not allowed to configure by the
user.
To Next Page
Loading...