Tsunami MP-8100 Installation and Management Guide 142
NOTE: When a particular priority is selected, the messages with a priority higher than the value selected will also be
logged. Change of priority does not change the priority of the messages already logged but only specifies the priority
of future messages to be logged.
To configure the System Log settings
1. Select a Log Status from the drop-down list.
2. Select a required Log Priority from the drop-down list: Emergency, Alert, Critical, Error, Warning, Notice, Info or
Debug.
3. Click OK.
Figure 5-14 Syslog Host Table
To add entries to the System Log Host Table
1. Click Add to display SYSLOG Host Table Add Row page.
2. Enter the parameters listed in the following table.
3. Click Add.
Figure 5-15 SYSLOG Host Table Add Row
To Next Page
Loading...