Tsunami MP-8100 Installation and Management Guide 149
In addition to the parameters displayed for Ethernet interfaces, the following parameters are displayed for the wireless
interface.
Parameter Description
RSSI Statistics
RSSI stands for Received Signal Strength Indicator. For receiving strong signal, the RSSI should be high.
This section displays the Receiver statistics. It indicates the power viewed across the receiver input.
Antenna Specifies all the antenna ports available for the product. This is
based on the product option.
Status Specifies the configuration status of the antenna ports. ON
indicates that antenna port is enable for that chain. OFF means
antenna port is disabled for that chain.
Control Specifies the RSSI value of the packet received on the selected
channel.
Extension Specifies RSSI value of the packets received on the adjacent channel
(20MHz). This parameter is applicable only for the 40 MHz modes,
i.e., 40 PLUS and 40 Minus modes.
Rx Error Details
Decrypt Errors This parameter is applicable if the Security is enabled. It indicates
the number of received packets that failed to decrypt.
CRC Errors Specifies the number of received packets with invalid CRC.
To Next Page
Loading...