Installation and Initialization
Tsunami MP-8100 Installation and Management Guide 32
2.5.2 COMMIT Button
Commit button is used to apply the configuration changes into the unit. When changes are made to the configuration
parameters of the device, until the COMMIT button is clicked, the changes will not take effect. Some parameters may require
system reboot for the changes to take effect. On clicking COMMIT, the system evaluates all the configuration dependencies
and displays the configuration status.
Before applying commit, the system displays a confirmation message, as shown in the following figure:
In some cases, upon successful COMMIT operation, a message “Please Reboot to take effect” appears as follows:
2.5.3 REBOOT Button
Reboot operation is required for any change in the key parameters to take effect. For example, settings such as configuring
the Radio Mode, IP Address, and Network Mode need reboot to take effect.
It is recommended that the device must be rebooted immediately after modifying a rebootable parameter. System displays a
confirmation window, wherein click OK.
To Next Page
Loading...